中文
English
Hot Tel
+8613791907665
+8613791907665
technical parameter
Equipment Introduction
1. This machine is mainly designed and produced according to the working principle of hot pressing equipment, the operation process: putting sheet - feeding - heating - pressing - holding pressure - forming - slitting and other steps, the appearance is neat and generous Practical, table plate processing all use machining centre processing, to ensure the accuracy of all hole size, column and shawl exterior are plated with hard chrome quenching treatment, to ensure the sliding and wear resistance, machine system edited into two parts of manual and automatic, in the manual case all actions can be single operation.
2. feed motor is driven by a servo motor with 2.3 kW.
3. Discharge reducer motor 0.18KW with 1:10 special reducer to ensure discharge speed!
4. Ceramic heating block: new type of ceramic heating block, fast heating up and power consumption, electric control bit to adjust the heat freely.
5. Other mechanical parts are produced and processed by ourselves. Automation of all circuits: PLC control.
6. The machine adopts the full curved arm design, the overall balance is better, solving the situation of left and right high and low in the production of the double cylinder machine, extending the use of the mould.
Equipment body profile
| Serial No. | Standard specification or equipment configuration name | Key indicators |
| 1 | Forming (cutting) longest range | 0.5 m - infinite length (cut in full die multiples) |
| 2 | Forming (cutting) width range | 600-800mm, width adjustable |
| 3 | Applicable sheet thickness | 0.15-0.90mm |
| 4 | Maximum height for forming | 100mm |
| 5 | Production efficiency | Machine timing 3-8 seconds per mould, depending on the forming effect |
| 6 | Product type and mould form | Suitable for all kinds of waveform moulds |
| 7 | Release method | Bi-directional separation of moulds |
| 8 | Heating method | Single control, single sided heating |
| 9 | Total heating power | 22 kW |
| 10 | Temperature control and regulation systems | Temperature control with solid state heating |
| 11 | Main motor power | Motor 7.5KW |
| 12 | Cooling system type and power | Internal flow channels in the beam to ensure cooling of the beam |
| 13 | Rated maximum power of the whole machine | 32KW |
| 14 | Actual energy consumption for normal production of the whole machine | 23KW |
| 15 | Power supply | 380V 50HZ (3-phase 4-wire) |
| 16 | Pneumatic system power | 0.8MPA |
| 17 | Dimensions of the complete machine | 5M long, 1.5M wide, 1.8M high |
| 18 | Total weight of the machine | Around 4000KG |
Product application notes:
